I just got it today. Let’s see what different from their brother. This is small size quad copter from DJI. Small package with short arm length. Size of motor to motor is 330mm (33cm). Can compare with Gaui 330X. The package box is same as before. ARF sticker like F450, F550. Package contain: – 1…
“If a notebook is thin and light enough to carry with you everywhere you go, it should be powerful enough to handle everything you do. The new MacBook Air is more than up to the task — whatever the task may be.” So long my old macbook pro. You serve me well. And welcome macbook…
I’m using XBee on APM 1.0 before. But it stop working with unknown reason. Today I decided to get replacement Xbee and I choose “XBee Pro 900 RPSMA”. It can use external antenna and also support my old 900Mhz module (I feel like it only broke one). The setup on Xbee module is really easy.…
I can confirmed. DJI make really easy to setup product. I play around with DJI Naza before moved to DJI WK-M. Both are really easy to setup. Just only 30 minutes and you can rock the sky. I’ll shared the setup screen soon.
This is my first flight with APM 2.0. I decided to plug this board into Gaui 500X. It quite easy to maintenance for me. After a few hours to play around with board, configuration and tune up. I finally fly it. But not good yet. I just finished tune up on Arco and Stable mode.…
Last post about DJI F550 build log. And DJI F550 with X468 Gimbal. I’m forget to show how I mount it together. First) Place double side tape below red box in picture. I use 3m clear double side tape. Second) Before you drill bigger hole on gimbal. Please check alignment and drill new hole at…
After 2 months pre-ordered for this board. I finally got it. This board is look so slim and totally different from first version. Mainly upgrade point from my old APM 1.0 is ATMega 2560, New Barometer and buildin GPS. This only one board with slim plug-in board. Please see this photo I have no comment on…
Welcome on board WooKong-M. This is really big investment for me. First time I got the package and opened it. It make me feel amazing. I never see product from china better like this. The design, material on body and cable is really good. Big change from DJI Naza is separated sensor IMU, GPS, Power module.…
Put Gimbal and F550 together. This make my F550 look more and more better. But you have to put double-side tape between Frame and Gimbal then screw the nylon nut between gimbal and frame. Or you have to drill another hole on Gimbal to make gimbal lock into position. [Thank you alex to correct me…
Last time I got OSD system from Eagle Tree Systems. OSD Pro/GPS/eLogger. But when put everything into Quad rotor. Only GPS latitude, longtitude information can be use. GPS altitude are not accurate. So I decided to purchase two more sensor, – Eagle Tree Guardian (This will use for show horizontal line on OSD) – Eagle…