Gaui 500X with DJI WK-M
I can confirmed. DJI make really easy to setup product. I play around with DJI Naza before moved to DJI WK-M. Both are really easy to setup. Just only 30 minutes and you can rock the sky. I’ll shared the setup screen soon.
Gaui 500X with APM 2.0
This is my first flight with APM 2.0. I decided to plug this board into Gaui 500X. It quite easy to maintenance for me. After a few hours to play around with board, configuration and tune up. I finally fly it. But not good yet. I just finished tune up on Arco and Stable mode.…
DJI WK-M Welcome on board
Welcome on board WooKong-M. This is really big investment for me. First time I got the package and opened it. It make me feel amazing. I never see product from china better like this. The design, material on body and cable is really good. Big change from DJI Naza is separated sensor IMU, GPS, Power module.…
DJI Naza Parameter for DJI F450, Gaui 500X
I would like to share my current parameter for DJI F450 and Gaui 500X DJI F450 – 4 x DJI Motor 920KV – 4 x DJI ESC 30A Opto (no BEC) – DJI Props 10×4.5 – Frame length 450mm Pitch: 120 / Roll: 120 / Yaw: 135 / Vertical: 120 Atti Roll: 85 / Atti…
Gopro HD Hero2 – Sky Shot
Sky shot on Gaui 500X and DJI Naza. I do the hard mount Gopro with expansion plate. So it have some “Jelly effect” when forward fly and climb up.
Altitude Hold mode Arducopter 2.2b4 with Gaui 500X
Equipment: – Ardupilot APM1.0 (1280) + Oilpan – MB 1240 XL-EZ4 Sonar from Maxbotix – Frame Gaui 500X with 330X-S Motor/Speed Result: After adjust some ALT_HOLD_P and THR_P gain. Overall Altitude hold was good. Because of beam behavior on EZ4. It may cause altitude change immediately a bit. And some test on barometer hold was…
DJI Naza with Gaui 500X (Upgrade from 330X-S)
Equipment: – DJI Naza – Gaui 500X Frame – Gaui 330X-S Motor x 4 – Gaui (Turnigy) 10A ESCs x 4 – 8×4.5 props Following screen shot will show all setting for Gaui 550X frame. Its fly perfect for me ;-). 1) Motor Mixer: Quad-rotor X